Question:High-speed driving or rough roads cause the mirror to shake violently
Answer:Please use low-strength screw glue on all accessories screws, which can increase the rigidity of the screws and reduce vibration

 

 Question:Mirror mounts interfere with the use of long clutch and brake levers

Answer:You can install the mirror from the bottom, and then adjust the position. Or you can replace the short lever

 

 Question:Expansion sleeve adapter loose
Answer:Use electrical tape (or other tape) to wrap the sleeve

 

 Question:how you want to mount on the original bar end weight

Answer:Use electrical tape (or other tape) to wrap the sleeve

 

 Question:The bracket of mirror will affect the use of the throttle grip

Answer:You can adjust the position or cut the excess grip or Use spacers to increase spacing

 

 Question:How to install kawasaki Z650 and Ninja650

 Answer:There are 2 installation options

Plan1:you need to remove the rod inside the original handlebar
Remove the metal clips from the original pole
Then push the rod to handlebar deeper
leaving a gap of 4-5CM at the end of handlebar
and then use the “Installation method Sleeve expansion”
This method can keep the original factory state

Youtube video link:https://www.youtube.com/watch?v=105yLtRGBWM&list=PLACGCq4SoNuvqR3bq72L62rgiT0tFdqyM&index=2

Plan2:you need to remove the rod inside the original handlebar, and then use the expansion sleeve to install, you can refer to this youtube video and photo.

Youtube video link:https://www.youtube.com/watch?v=ecXDwtcfbkg

 

 Question:801-0374 model How to install kawasaki model

Answer:Please prepare 4-5 pieces of washers by yourself.Remove the original bar end weights, then install the mirrors and washers, then install the original weights

 

 Question:How to install Honda CB and CBR model

Answer:There are 2 installation options

Plan1:you need to remove the rod inside the original handlebar Remove the metal clips from the original pole Then push the rod to handlebar deeper leaving a gap of 4-5CM at the end of handlebar and then use the “Installation method 1 or 2” you can refer to this video and photo

Youtube video link:https://www.youtube.com/watch?v=105yLtRGBWM&list=PLACGCq4SoNuvqR3bq72L62rgiT0tFdqyM&index=2

Plan2:you need to remove the rod inside the original handlebar, and then use the expansion sleeve to install, you can refer to this youtube video and photo.

Youtube video link:https://www.youtube.com/watch?v=BgkFub-SvlY&list=PLACGCq4SoNuvqR3bq72L62rgiT0tFdqyM&index=3

×

Someone recently bought a

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Your cart

×